Apple FireWire Cable User Manual

Xserve  
FireWire Cable  
Replacement Instructions  
Follow the instructions in this sheet carefully. Failure to follow these instructions could  
damage your equipment and void its warranty.  
Note: Online instructions covering customer-installable parts are available at  
Tools Required  
No tools are required for this procedure. You may, however, find a Phillips screwdriver  
useful in releasing the thumbscrews at the front of the server.  
Opening the Server  
The server slides open from the front of the rack. The top cover remains in place in the  
rack while the bottom housing (containing all internal components) should be placed on a  
sturdy, at surface.  
1. Alert users that the server will be unavailable for a period of time.  
2. Shut down the server.  
Warning: To avoid damaging internal components or causing injury, always  
shut down the server before opening it. After you shut down the server, internal  
components can be very hot. Let the server cool down before continuing.  
3. Write down the server’s serial number, which is located on the back panel. If it is  
necessary to set up the server’s software after you replace the FireWire Cable, you  
will be asked for the serial number at login.  
073-0678 Rev. A  
9. Grasp the thumbscrews and slide the bottom housing forward part way to expose the  
two chassis levers. (Figure 2)  
10. While depressing both levers, pull the bottom housing all the way forward and remove  
it from the rack.  
Figure 2  
11. Place the bottom housing on a sturdy, at surface and ESD mat.  
12. Put on the ESD wrist strap.  
Xserve FireWire Cable - 3  
Removing the Installed FireWire Cable  
1. Disconnect the FireWire cable from the front panel board. (Figure 3)  
2. Disconnect the FireWire cable from the drive interconnect board and remove the cable  
from the server.  
Figure 3  
Installing the Replacement FireWire Cable  
Connect the replacement FireWire cable to the drive interconnect board and the front  
panel board.  
Closing the Server  
1. Carefully slide the bottom housing back into the rack.  
2. Tighten the front thumb screws to secure it.  
Warning: Never turn on the server unless all of its internal and external parts  
are in place and it is closed. Operating the server when it is open or missing  
parts can damage it or cause injury.  
Xserve FireWire Cable - 4  
Apple Computer, Inc.  
© 2002 Apple Computer, Inc. All rights reserved.  
This document is protected under U.S. Copyright Law and International Treaties, and no  
part of this document may be reproduced in any form without written permission from  
Apple.  
Apple is not responsible for typographical, printing, or inadvertent errors.  
Apple Computer, Inc.  
1 Infinite Loop  
Cupertino, CA 95014-2084  
USA  
+ 1 408 996 1010  
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple  
Computer, Inc., registered in the U.S. and other countries. Xserve is a trademark of Apple  
Computer, Inc.  
Xserve FireWire Cable - 5  

Hanns G HG 216DP0 User Manual
Eiki LC XGA980U User Manual
Curtis RMW1172 User Manual
Chauvet 160 LED User Manual
Bosch Appliances Computer Hardware SMB365 User Manual
BenQ Computer Monitor G900AD User Manual
AT T TL92320 User Manual
AT T DECT CL82859 User Manual
Asus Computer Monitor VE198 User Manual
Aastra Telecom BE 100HT User Manual